Sold

Alder

Designed and fabricated by Site Seven in Chattanooga, Tennessee.

The next one starts with a conversation.
Start a build with Alder as the reference See all builds
Chassis
2021 Sprinter 170 4x4
Seats / sleeps
2 / 2
Model year
2021
Mileage
23000
Built in
Chattanooga, TN
Sold
Start a build with Alder ...

Built for a couple who wanted a maple interior, a full galley, and a garage that carries the bikes

A maple interior over a working garage.

Alder is a 2021 Sprinter 170 4x4 with a full maple wall and ceiling package, a large kitchenette with a stainless counter and Richlite drawer faces, and bench-to-bed seating that opens into a second sleeping space. The casework is powder coated in semigloss black with non-slip trim on the floor.

Behind the rear platform bed, wheel boxes and a slide-out tray make the garage usable for gear, and the 200Ah Victron system with solar and shore charging runs the Espar heater, the Dometic air conditioner, and the Eccotemp water heater.

Systems

What is on the van, system by system. Hover a component to see it.

Electrical

A 200Ah Victron system with solar and shore charging, sized for a couple off grid.

Also on this van
  • 200Ah Victron lithium system
  • 800W Victron inverter
  • Victron shore power charger
  • Solar system with Victron charge controller
  • Full LED lighting package, garage lights

Comfort and safety

Full insulation behind a maple interior, with diesel heat and battery-powered air conditioning.

Also on this van
  • Espar diesel heater
  • Dometic RTX 2000 12V air conditioner
  • Full insulation package
  • Maple wall and ceiling package with maple trim
  • Coin flooring with non-slip powder-coated trim
  • CO and smoke detector, fire extinguisher

Water and galley

Two tanks, a rear-mounted on-demand heater, and a stainless galley.

Also on this van
  • 20 gallon interior fresh tank, 25 gallon exterior tank
  • Eccotemp rear-mounted water heater
  • Stainless countertop, stainless sink with residential faucet
  • Richlite door and drawer faces
  • Large kitchenette, upper cabinet with shelf
  • Driver-side marine table mount

Sleeping and seating

A rear platform bed and a bench that becomes a second bed, with a garage that slides out.

Also on this van
  • Rear platform bed
  • Bench-to-bed seating with premium upholstery
  • Rear wheel boxes and rear slide-out tray
  • Driver-side upper cabinet

Chassis and suspension

A 3.0L V6 4x4 Sprinter with on-demand four-wheel drive and a Van Compass suspension.

Also on this van
  • 2021 Mercedes Sprinter 170 4x4, 3.0L 6 cylinder turbo diesel, 188 hp
  • 7G-Tronic automatic, 220 amp alternator
  • MBUX with navigation and rear camera; adaptive cruise, blind spot, lane keeping, active brake assist
  • On-demand 4WD with high and low range
  • 5,000 lb trailer hitch with 7-pin connector
  • Van Compass suspension system
  • Tire and wheel package

Exterior

Rack, scene lighting, and Owl Vans gear.

Also on this van
  • Site Seven roof rack
  • Exterior scene lighting
  • Owl Vans gear
  • Rear pill windows

More of the interior

How a build like this starts.

  1. Ask a question or book a walkthrough.Use the form on this page. Your message comes to Justin with this build attached, so the first reply is about this van, not a form letter.
  2. Walk the van.In the shop in Chattanooga, or on a video call with Justin from inside the van.
  3. Financing and delivery.Financing is available. Delivery is arranged around your schedule.

Warranty

1 year Site Seven craftsman warranty on the build. Electrical components warrantied up to 10 years. 5 year, 100,000 mile Mercedes extended warranty on the chassis. Site Seven helps with individual part warranties as needed.

Standards every Site Seven build shares

No particle board and no mass-produced interior kits. Wool insulation and sound deadening as standard. Marine-grade flooring and fabrics. CO2 and smoke detection and a fire extinguisher in every van.

Start a build with Alder as the reference.

Alder has an owner. If this layout is close to what you want, tell Justin what you would keep and what you would change. That conversation is where every custom build starts.